AutoEnginuity Unveils Giotto Version 19.0.0

The release of Giotto Version 19.0.0. was announced recently by AutoEnginuity Acquired in 2017 by Opus IVS. 

FREMONT, CA: AutoEnginuity announced the release of Giotto Version 19.0.0. by Acquired in 2017 by Opus IVS, AutoEnginuity is a multinational engineering company that specializes in data streaming and diagnostic solutions for vehicles. The 21MY support is introduced by Giotto® 19.0, and the upgrade of improved BMW, MB, Porsche with combined data sets continues, and the process of porting functionality to hardware J2534 continues. For Windows PC ONLY, this is the new Giotto. AE server products, iOS, and Android will come soon.

The additions consist of:

Giotto Version 19.0.2051

Audi / VW / SEAT

• Added 21MY support

BMW / MINI

• Added 21MY support

• Added full support for electric 48V systems

Chrysler-family

• Added 21MY support

• Fixed VIN programming for PCM Var 23 modules (i.e., Jeep Wrangler '13)

Ford-family

• Fixed MKX 11 - 15MY not having the Headlight Control Module available

• Fixed Edge 13 - 20MY PCM missing EVAP Temperature sensors

• Added 21MY support

• Improved Navigator and Expedition 11 - 20MY BCM missing sensors for PATs

GM-family

• Added 21MY support

Honda / Acura

• Added 21MY support

• Fixed ABS table issue for the Acura MDX vehicles

Hyundai / Kia

• Added 21MY support

• Added K5 full model support

• Added Electric Water Pump Control, HSG Resolver Calibration, Remove Air from Engine Clutch Hydraulic Pressure Line, Stabilization of Hydraulic Engine Clutch S/W Management support HEV models

• Added Remove Air from Engine Clutch Hydraulic Pressure Line, Stabilization of Hydraulic Engine Clutch, Compression Pressure Test of Engine Cylinder S/W Management support for HEV models

• Added Isolation Breakdown Detection Function S/W Management support for HEV models

• Enhanced HEV sensor lists and actuation instructions.

Jaguar

• Added 21MY support

Land Rover

• Added 21MY support

• Added Defender (L663)

• Fixed EnhancedPowertrainCAN not reporting DTCs if they take longer than 1 second to inform

Jaguar

• Added 21MY support

Mazda

• Added 21MY support

Mercedes Benz / Smart

• Added 21MY (S-Class 223 chassis not supported at this time)

Mitsubishi

• Added 21MY support.

Nissan / Infiniti

• Added 21MY support.

• Fixed BCM Rev11 not clearing codes on specific Nissan models.

• Fixed Maxima 20MY not supporting Lane Camera system

Porsche

• Added 21MY support.

Subaru

• Added 21MY support.

• Added Ventilation Seat, Front Relay Control Module, and Door Mirror Drivers for Outlook and Legacy models

• Completed support for Ventilation Seat, Front Relay Control Module, and Door Mirror Drivers

• Fixed EnhancedPowertrainCAN did not pull past DTCs

• Fixed EnhancedPowertrainCAN actuations not resetting after an error was displayed

Toyota / Lexus / Scion

• Added 21MY support

• Added Front Recognition Camera PCSImageInfoClear, InitialAxisAdjustValueDisplay, RecogCameraTargetPosMemory, RecogCameraAxisAdjust